Why Is My Laminate Floor Not Laying Flat

When you are installing snap and click laminate flooring you will need a soft rubber mallet and block of wood.

Why is my laminate floor not laying flat.

The bulges probably mean that the floor is not flat which means starting over again i m afraid. This situation can be easily remedied. This is a serious problem because it usually means the boards are damaged and need to be replaced. When you remove the floor boards and replace them be sure to cover the subfloor with a layer of plastic or tarpaper so it doesn t happen again.

All the individual pieces interlock into one sheet that lays or floats on the sub floor. And don t forget to lay an underlay felt or a rubber composite type floor covering. Laminate flooring is said to float because it is not fastened to the sub floor. Installers avoid it by laying a moisture barrier between the laminate and the subfloor.

Loose lay vinyl flooring is extremely popular because of its durability and easy installation process but it does have a tendency to buckle if heavy furniture is dragged across the surface of the floor. Some locking systems are can be damaged from the tapping. You must check and control the flatness. Use caution when using a block of wood and a mallet on some laminate flooring.

Very common installation mistake. The block of wood can be a scrap piece of wood as long as it is flat on both sides. When properly installed it should have a gap of approximately 1 4 inch from the walls of the room on all sides. Not all vinyl plank flooring requires a glue down installation process.